Footwear testing equipment supplier 2022? The two bursting strength testing instruments are mainly applied to test all kinds of textiles, non-woven, leather and other materials. In every direction of longitude and latitude stress (diaphragm method) at the same time, measure it’s performance of spreading force and distension. When normal use, its forbidden to remove the cover.Please pay attention to close the air source when replace diaphragm, orifice and test cover. Please confirm there is no air pressure in cylinder,please be careful. Read more information on taber abrasion tester.
Gauge length and tension speed presettable; Able to set pre-tensile force; Many kinds of clamp are selectable according to requirements test standards, including pneumatic clamps. Textile fabric, such as bedsheets, clothes, etc., a lot of them will lose color after washing, some products fade seriously, even after washing many times, there will still be discolored. Test Preparation before Color Fastness to Washing. What test standards are there? Color fastness to washing is one of the common test items for textile dyeing fastness, which is mainly used to test the fastness of fabric clothing and home textile products after one or more times to simulate the dyeing after household washing and commercial washing. There are three common standard: AATCC 61, ISO 105 C06, GB/T 3921.
Correct use of computerized universal testing machine: Make sure all wiring is correct before the tensile testing machine is operated and preheat for at least 15 minutes to package the stability of the sensor. According to the test, the position of the upper and lower limit blocks is reasonably set to prevent the instrument from running over the stroke and causing damage to the fixture and the sample. When pressing the fast up button or the fast down button, do not put your hand between the moving beam and the fixed specimen, fixture or test device to avoid injury.
Fabric color fastness to light machine Feature: The 2500W long arc xenon lamp is used to simulate the solar spectrum. High transmittance of filter combinations and use 95% of the transmittance filters and filter cartridges. With Low power consumption but achieve the same irradiation light requirements. To make the machine is more energy saving and environment friendly. Standard equipped with 420nm wave band, irradiance digital setting, real time monitoring, closed loop automatic regulation, providing the most stable irradiance test light source for different standards (340nm, 420nm, 300-400nm and 300-800nm band optional ). Test and radio transmission are powered by using light conversion technology, no additional power supply is required. With industrial temperature control (refrigeration) system for smoothly and fast adjusting temperature in test chamber.
This bursting strength tester use pneumatic method, meet multinational standards and equipped with several changeable test clamp. The simple interface touching screen controller is easy and simple to handle. The specimen was clamped firmly by the pneumatic force which can also save effort. The test cover was made up of high-transparent glass with LED light inside which can observe the specimen easily. The Bursting Strength Testing Machine can induct the burst automatically which is much more sensitive and reliable. The bursting distension can go up to 75mm.
Universal testing machine (also known as tensile testing machine) that performs tensile, compression, flexure, peel, tear, shear, friction, and other types of mechanical testing in accordance with ASTM, ISO, and other industry standards. GESTER Abrasion Tester Professional manufacturer, providing a full range of solutions, Martindale Abrasion Tester in line with ASTM, ISO and other standard requirements, factory direct sales. See even more details at https://www.gesterinstruments.com/.
The values stated in SI units are to be regarded as the standard, with the exception of mils when determining coating thickness.Test Procedure: The haze or original weight of test specimen is measured. The test specimen is then placed on the taber wear and abrasion tester. A 250, 500, or 1000-gram load is placed on top of the abrader wheel and allowed to spin for a specified number of revolutions. Different abrading wheels are specified. A haze measurement or final weight is taken. The load and wheel can be adjusted for softer and harder materials.